Project
Skip to content

3D printing · Intermediate · 3 min

Design for 3D Printing (DfAM)

The rules that make designs print first time: the 45° overhang rule, bridging, minimum walls, holes and teardrops, clearances, chamfers vs fillets, text size and orientation for strength.

By the 3DA.XYZ editorsUpdated 2026-11-05Original renders & data

Overhangs and the 45° rule

Each layer needs something underneath. A wall leaning out up to about 45° from vertical usually prints cleanly because each layer overlaps the one below by roughly half a line. Steeper overhangs droop and need supports, a different orientation, or a redesign.

Our overhang test: six fins at 20°–70° from vertical show where your printer starts to droop.
Our overhang test: six fins at 20°–70° from vertical show where your printer starts to droop.

Print the overhang test once to learn your own limit; good part cooling can push it toward 60°.

Bridges

A bridge is a horizontal span between two supports. Most FDM printers bridge 10–30 mm cleanly, some much more, with the right speed and cooling. Test with the bridging test.

Walls and minimum features

  • Walls should be a whole number of line widths: with a 0.4 mm nozzle, 0.8 mm (2 lines) is a practical minimum; 1.2–1.6 mm for strength.
  • Details smaller than the nozzle width disappear. Raised text should be at least ~0.6 mm tall and about 5 mm high to stay legible.
  • Pins thinner than ~2 mm break easily along layers.

Holes

Printed holes usually come out undersized: plastic squashes inward and curves are approximated by flat segments. Common fixes:

  1. Add clearance — often 0.2–0.4 mm on the diameter. Measure with a tolerance gauge.
  2. Use the hole compensation calculator, including the polygon correction for faceted holes.
  3. For horizontal holes (axis parallel to the bed), use a teardrop shape whose top is a 45° point — no supports needed.
  4. For precision, print undersized and drill or ream.

Fits and clearances

FitTypical FDM clearance (per side)Use
Press fit0–0.1 mmParts that should not come apart
Snug / sliding0.15–0.25 mmLids, sliding parts
Free / loose0.3–0.5 mmHinges, rotating parts, print-in-place

Calibrate for your machine and material; see tolerances and fit.

Edges touching the bed: chamfer, don’t fillet

A rounded fillet on a bottom edge is a steep overhang at the very first layers and tends to curl. A 45° chamfer prints cleanly and also hides elephant’s foot. Fillets are fine on vertical and top edges.

Orientation decides strength

FDM parts are weakest between layers. Orient so that loads run along the layers, not across them: a hook printed lying flat is far stronger than one printed upright. Orientation also changes supports, surface finish and print time — see print orientation.

Split big or complex parts

If a part cannot be oriented without heavy supports, split it into pieces that each print flat, and join them with pins, dovetails or glue. Add alignment features rather than relying on the glue line.

Before you export

Check the model is closed and manifold in the 3D Studio, confirm its size and units, and run the print file checklist.

Check your understanding

1. Up to roughly what angle from vertical can FDM overhangs usually print without support?

2. Which edge treatment prints best where a part meets the bed?

3. Why do printed holes come out undersized?