Project
Skip to content

3D printing · Beginner · 3 min

FDM vs Resin vs SLS 3D Printing

How filament, resin and powder printers work, what each is good and bad at, typical layer heights, post-processing and safety — so you can pick the right process for the part.

By the 3DA.XYZ editorsUpdated 2026-11-05Original renders & data

Three ways to build in layers

FDM / FFF (filament)Resin (SLA, MSLA, DLP)Powder bed (SLS, MJF)
How it worksA hot nozzle draws each layer with melted plasticLight hardens liquid resin layer by layerA laser or heat fuses nylon powder
Typical layer height0.1–0.3 mm0.025–0.1 mm~0.1 mm
DetailGood; visible layer linesExcellent; near-smooth surfacesVery good; slightly grainy
SupportsFor overhangs beyond ~45°Almost always; small contact pointsNone — loose powder supports the part
StrengthGood, weaker between layersOften brittle (tough resins exist)Strong, nearly even in all directions
Post-processingRemove supportsWash in alcohol, cure under UV, remove supportsDepowder, bead-blast or dye
Where it livesHomes, schools, workshopsDesks with ventilationMostly industrial and print services

FDM: the everyday printer

Fused deposition modeling (also called fused filament fabrication) is what most people mean by “3D printer”. It is affordable, uses cheap filament in many materials, and prints large, functional parts. Its limits are visible layer lines, weaker bonding between layers, and the need for supports under steep overhangs.

Resin: fine detail

Resin printers cure photopolymer with UV light — a laser (SLA), an LCD mask (MSLA) or a projector (DLP). Layers as thin as 25 microns make them ideal for miniatures, jewellery masters and dental models.

Uncured resin is a skin and respiratory irritant and can cause sensitisation. Wear nitrile gloves and eye protection, work with ventilation, and cure waste before disposal.

SLS and MJF: strong parts without supports

Powder-bed fusion builds parts inside a bin of nylon powder that supports them, so complex interlocking shapes need no supports. Machines are expensive, so most people use them through online print services.

Choosing by part

You want…Choose
Brackets, enclosures, prototypes, cookie cuttersFDM
Miniatures, jewellery, smooth small figuresResin
Strong functional parts, living hinges, small production runsSLS / MJF (service)
Huge parts (helmets, props) cheaplyFDM, split into pieces

File preparation is the same

All three start from a closed, manifold mesh in STL or 3MF. Resin parts are often hollowed with drain holes to save resin; SLS parts need escape holes for trapped powder. Check the file first in the 3D Studio, then estimate cost with the resin calculator or print cost calculator.

Check your understanding

1. Which process needs no support structures?

2. Typical resin layer heights are…

3. What safety step matters most with resin?