Project
Skip to content

Original 3D model · Math & geometry · CC0

Helical spring

A 20 mm helix with six turns of 2.4 mm “wire” and capped ends.

Render of the Helical spring
Rendered by the 3DA.XYZ viewport from the published 3MF.

Measured from the file

Size (X × Y × Z)
22.4 × 22.4 × 38.39 mm
Triangles
9,244
Unique vertices
4,624
Volume
1,664.8 mm³ (1.66 cm³)
Solid PLA mass
≈ 2.1 g if printed solid in PLA
Surface area
2,840.9 mm²
Euler characteristic
2
Mesh check
Watertight, consistently oriented

Tips and uses

  • In PETG or TPU it compresses a little; in PLA it is mostly decorative.

Download in any format

The 3MF is the master file (millimetres, compressed, 108 KB, SHA-256 a4efdefc7cc04b7b…). Other formats are converted on your device from the same geometry:

3MF

How it was made

Generated by the open 3DA.XYZ generator with spring: diameter = 20, turns = 6, pitch = 6, wire = 2.4. Then welded, checked edge by edge and written to 3MF by the same engine as the Studio; the file was read back to confirm identical geometry. Geometry only — no physical print was tested. Licence: CC0 1.0.