Project
Skip to content

3D Lab · live generator · free

Gear Generator

Design an involute spur gear by tooth count and module, see pitch, outside and root diameters and the centre distance to its mate, then download STL, 3MF, OBJ, GLB or PLY.

Generating…

Parameters

Result

Size (X × Y × Z)
—
Triangles
—
Volume
—
Mass in PLA (solid)
—
Mesh check
—

Download

Generated on your device. Millimetres, Z up; GLB in metres, Y up. CC0 — use it for anything.

How the gear is made

The outline follows a true involute — the curve traced by a taut string unwinding from the base circle — so gears with the same module roll against each other with constant speed ratio. The generator computes the circles from the module m, tooth count z and pressure angle:

CircleFormula20 teeth, module 2
Pitch diameterm × z40 mm
Outside (tip) diameterm × (z + 2)44 mm
Root diameterm × (z − 2.5)35 mm
Base diameterpitch × cos(pressure angle)37.6 mm

Two gears mesh when they share the same module and pressure angle. Their centre distance is m × (z₁ + z₂) ÷ 2 and the speed ratio is z₂ ÷ z₁ — both shown above the export buttons.

Printing tips

  • Print flat with 0.2 mm layers or finer; 4 walls and 40% infill for working gears.
  • Add 0.1–0.2 mm to the centre distance for printed gears so they do not bind; check your printer with a tolerance gauge.
  • Fewer than about 17 teeth at 20° causes undercut in real gear cutting; printed gears are more forgiving, but very small pinions have thin roots.
  • Nylon and PETG wear better than PLA (materials).

Ready-made gears: 12, 20 and 30 teeth at module 2.