Project
Skip to content

Original 3D model · Math & geometry · CC0

Möbius band (solid, printable)

A 14 mm strip with a half-twist, thickened to 2.4 mm so it is a printable solid. Run a finger along it: one continuous edge.

Render of the Möbius band (solid, printable)
Rendered by the 3DA.XYZ viewport from the published 3MF.

Measured from the file

Size (X × Y × Z)
58.43 × 61.72 × 14.2 mm
Triangles
1,920
Unique vertices
960
Volume
5,208.0 mm³ (5.21 cm³)
Solid PLA mass
≈ 6.5 g if printed solid in PLA
Surface area
5,196.9 mm²
Euler characteristic
0
Mesh check
Watertight, consistently oriented

Tips and uses

  • Print on its side with supports, or in two halves.
  • Compare with the zero-thickness surface below.

Download in any format

The 3MF is the master file (millimetres, compressed, 24 KB, SHA-256 9843946c08e7caf5…). Other formats are converted on your device from the same geometry:

3MF

How it was made

Generated by the open 3DA.XYZ generator with mobius: radius = 25, width = 14, thickness = 2.4. Then welded, checked edge by edge and written to 3MF by the same engine as the Studio; the file was read back to confirm identical geometry. Geometry only — no physical print was tested. Licence: CC0 1.0.