Project
Skip to content

Original 3D model · Gears & mechanical parts · CC0

Washer for M8

A flat 20 mm washer with an 8.4 mm hole — the standard clearance for an M8 bolt.

Render of the Washer for M8
Rendered by the 3DA.XYZ viewport from the published 3MF.

Measured from the file

Size (X × Y × Z)
20 × 20 × 2 mm
Triangles
768
Unique vertices
384
Volume
517.1 mm³ (0.52 cm³)
Solid PLA mass
≈ 0.6 g if printed solid in PLA
Surface area
695.5 mm²
Euler characteristic
0
Mesh check
Watertight, consistently oriented

Tips and uses

  • A quick dimensional check: measure the hole after printing.

Download in any format

The 3MF is the master file (millimetres, compressed, 7 KB, SHA-256 3c265a8c4f165717…). Other formats are converted on your device from the same geometry:

3MF

How it was made

Generated by the open 3DA.XYZ generator with washer: outer = 20, inner = 8.4, thickness = 2. Then welded, checked edge by edge and written to 3MF by the same engine as the Studio; the file was read back to confirm identical geometry. Geometry only — no physical print was tested. Licence: CC0 1.0.