Project
Skip to content

Original 3D model · Calibration & test prints · CC0

Bridging test (10–40 mm spans)

Pillars joined by a 2 mm deck over 10, 20, 30 and 40 mm gaps, to see how far your printer can bridge in mid-air.

Render of the Bridging test (10–40 mm spans)
Rendered by the 3DA.XYZ viewport from the published 3MF.

Measured from the file

Size (X × Y × Z)
120 × 10 × 10 mm
Triangles
76
Unique vertices
40
Volume
4,000.0 mm³ (4.00 cm³)
Solid PLA mass
≈ 5.0 g if printed solid in PLA
Surface area
4,040.0 mm²
Euler characteristic
2
Mesh check
Watertight, consistently oriented

Tips and uses

  • Look under each span: sagging strands mean too hot, too slow or too little cooling.
  • Tune bridge speed and fan in your slicer, then reprint.
  • See troubleshooting.

Download in any format

The 3MF is the master file (millimetres, compressed, 2 KB, SHA-256 316ec241639e8dff…). Other formats are converted on your device from the same geometry:

3MF

How it was made

Generated by the open 3DA.XYZ generator with bridge: spans = [10, 20, 30, 40], height = 8, depth = 10. Then welded, checked edge by edge and written to 3MF by the same engine as the Studio; the file was read back to confirm identical geometry. Geometry only — no physical print was tested. Licence: CC0 1.0.