Project
Skip to content

Beginner tutorial · 5 minutes

Make Your First 3D Model

A measured box, checked from every side, exported to real STL and 3MF files and verified — the habits behind every good model.

By the 3DA.XYZ editorsUpdated 2026-11-05Original renders & data

1. Set a target

Your first model should make mistakes obvious. A box with three different sides does that: if a side comes out wrong, or the box is rotated, you will see it at once. Use 20 mm wide (X), 40 mm deep (Y) and 30 mm tall (Z).

Before you start, picture it: one pair of faces is 20 × 30 mm, another 20 × 40 mm, the last 40 × 30 mm. Each view shows only two of the three measurements — that is the difference between 2D and 3D.

2. Make the box

  1. Open the 3D Studio and expand Make a shape.
  2. Choose Box. Set Width X 20, Depth Y 40, Height Z 30.
  3. Press Make shape. The view shows the new box sitting on the grid, and the size readout says 20 × 40 × 30 mm (always in X × Y × Z order).

The box is centred on X and Y and rests on Z = 0, the way a part sits on a printer’s bed.

3. Inspect it from every side

Drag to orbit until you see three faces at once. Then press Front, Right and Top with Orthographic on: each shows a flat rectangle with two of your three measurements. Turn on Wireframe: every face is split into two triangles, 12 in all, joining 8 corners.

The mesh report should read 12 triangles, 8 unique vertices, a volume of 24,000 mm³ (20 × 40 × 30) and “Passes the edge checks”. Moving the camera never changes those numbers — only editing the shape does.

4. Export real files

In Export / convert, press STL (binary), then 3MF. Rename them something like box-20x40x30mm.stl so the intended size travels with the file. STL stores only triangles; 3MF also records that the numbers are millimetres. Compare formats.

5. Reopen the file you exported

Drop the downloaded STL back onto the Studio. Same size, same 12 triangles, same volume? Then the export is faithful. This step separates “what I saw on screen” from “what I am sending to the printer”, and it catches unit mistakes before they waste material.

Try itCompare with our original 20 × 30 × 40 mm block — the same box, rotated, made by a different program. Open the block →

6. Make one controlled change

Change only Depth Y from 40 to 20 and press Make shape. The readout becomes 20 × 20 × 30 mm and the volume halves to 12,000 mm³. Export it under a new name. You now have two files whose difference you can explain exactly — the habit that makes every later model easier.

Ready for curves? Try Cylinder with 64 segments, then 8, and watch how the triangle count sets smoothness. Triangle count explained. When you outgrow simple shapes, choose a full tool using mesh, CAD, sculpting or scanning.

Sources and further reading