Project
Skip to content

3D Lab · calculator

E-Steps Calibration Calculator

Calibrate your extruder: mark the filament, extrude a known length, measure what actually moved, and get the corrected steps per millimetre.

Calculated in your browser. Nothing is uploaded or saved.

Enter values to calculate.

The procedure

  1. Heat the nozzle to printing temperature.
  2. Mark the filament 120 mm above the extruder inlet.
  3. Command 100 mm of extrusion slowly (for example G1 E100 F100 in relative mode).
  4. Measure the remaining distance to the mark: if 23 mm remain, 97 mm was extruded.
  5. New E-steps = current × requested ÷ actual. Save it in firmware.

Then fine-tune flow in the slicer. Correct E-steps fix a whole family of under-extrusion problems.